Foundation Repair in Holliday, TX: Free On-Site Inspection, Then a Written Quote

Kamay clay covers more of Holliday than of any other town we serve. Your quote follows a free on-site elevation survey.

  • Free on-site inspection with elevation readings
  • Written itemized quote before any work starts
  • About fifteen miles out US 277 and US 82, about eighteen minutes

Get a free written quote

Open french drain trench lined with filter fabric, washed stone and perforated pipe beside a house
  • Free on-site inspection
  • Written itemized quote
  • Scheduling window quoted up front
  • Warranty terms in writing

Wichita Falls Foundation Works provides foundation repair in Holliday, setting pressed concrete cylinder piles under settled slabs and quoting your job in writing after a free inspection. In USDA soil survey data, Kamay clay covers 35.2 percent of the town, the highest share of any town this site covers, at a linear extensibility of 7.5. Our crew comes out US 277 and US 82 in about eighteen minutes, so call (940) 202-0406 for a written price.

Foundation work we do in Holliday

Slab repair. We lift a settled slab on pressed concrete cylinder piles, set under the affected sides of the grade beam. Holliday's heavy Kamay clay often needs this slab repair.

Pressed concrete pilings. We set each pile from a hand-dug exterior pit at the grade beam, cylinder on cylinder, pressed until refusal. Dense Kamay clay here calls for pressed concrete cylinder piles.

Steel push piers. Where a pressed pile won't reach firm bearing, we bolt a bracket to the footing and drive pipe sections. Ask for each pier's load-test reading before the lift. Newer 1980s footings sometimes need steel push piers.

Pier and beam work. Under a raised floor we set shims and new piers under the girders, and replace any joist or sill plate that has gone soft. Some older Holliday homes still need pier and beam repair.

Elevation survey. We take floor readings with a zip level before any price, room by room, and the numbers go on your written quote. A newer stock still settling is why we start with an elevation survey.

Drainage and water. We quote French drains, regrading away from the slab and downspout extensions separately, because water that sits against a beam undoes pier work. Lots near Holliday Creek often need this drainage correction.

Stair-step cracking through the mortar joints of a brick veneer wall near a corner

Why houses in Holliday move

Kamay is 35.2 percent of Holliday's own footprint, higher than the Wichita Falls city footprint itself, with Deandale behind it at 15.4 percent and an even higher 8.5 linear extensibility; the Archer County survey puts Kamay's clay subsoil at 45 percent clay.

Census data dates the median house here to 1984, twelve years newer than the city, with the 1980s the biggest decade by far, so movement is often a first event rather than fifty-year-old damage. The federal soil survey also maps oilfield-waste ground here, more than any other town in the service area.

What foundation repair costs in Holliday

Pile count follows how many sides have moved, and pits through 35 percent Kamay clay run steady but deep, though rural lots leave room for the spoil pile. Either way, we put the drive in our scheduling window, never in the price. We price every job after a free on-site inspection and an elevation survey.

Holliday foundation prices, 2026
WorkTypical rangeNotes
Whole slab job, pressed concrete pilings on the affected sides$3,500 to $8,500 per job8 to 15 pilings on a typical single-story house
Pressed concrete cylinder pile, exterior pit at the grade beam$300 to $700 per pile installed
Steel push pier, driven to refusal$500 to $1,500 per pier installed
Pier and beam repair, whole job$2,000 to $12,000 per jobre-shim at the bottom of the band, new piers and beam work at the top

Swipe the table sideways to see the notes column.

Typical ranges. Priced after a free inspection.

Hydraulic ram down in an open pit pressing a concrete cylinder pile under a house's grade beam

How the job runs in Holliday

  1. A free on-site inspection at your house comes first: elevation readings room by room, a walk of the outside with you, and a written itemized quote with a scheduling window before we book anything.
  2. Where the readings point at water, we run a static or hydrostatic plumbing test first. A leaking line under the slab gets fixed before anyone prices piles.
  3. We hand-dig pits at the grade beam at the marked spacings, plywood goes on the grass and spoil goes on tarps, and the piles are pressed to refusal.
  4. The house comes up in sections while one of our crew reads elevations inside. We set shims, fill the voids, backfill the holes and haul off the spoil.

Soil, water and weather in Holliday

About 7 percent of Holliday's own footprint is frequently or occasionally flooded Port and Wheatwood ground along Holliday Creek, the waterway the town is named for, with Lake Wichita, built along that creek about 1900, roughly five miles east. NOAA's regional gauge at Wichita Falls averages 27.89 inches of rain a year over 1991-2020, with 104.7 days at 90 degrees or hotter.

Line of fresh topsoil patches along a brick wall where pier holes were backfilled after the work

Towns near Holliday we also drive to

From here we also reach Archer City and Lakeside City, both sharing Holliday's Archer County soil survey. Wichita Falls sits about fifteen miles east, and all service areas are listed on one page.

Every service we offer in Holliday

What happens when you call

The inspection

A free on-site inspection comes first. We come to the property, look at the work in person, measure, and check the things that change the price before quoting anything.

A written, itemized quote

Every line item goes on paper before any work starts: prep, materials, labor, cleanup and the scheduling window. No verbal numbers.

Warranty terms in the contract

Workmanship and material warranty terms come in writing and go in your contract so you can read them before you sign.

Scheduling you can plan around

You get a start window and a working-day estimate up front, and the crew tells you before anything changes.

Who this is not for

Wichita Falls Foundation Works handles foundation repair and the related work listed on this site. It does not take on unrelated trades; if your job is outside that scope, a specialist in that trade is the right call.

Questions Holliday homeowners ask

Do you really drive out to Holliday, or is this a Wichita Falls crew that stays in town?

Yes. The run is about fifteen miles out on US 277 and US 82, eighteen minutes. See the towns we cover for the full list. You get the same free inspection and the same written quote as a house in town.

What does foundation repair cost in Holliday, per pile and for the whole job?

Most whole slab jobs run $3,500 to $8,500, at 8 to 15 pressed concrete cylinder piles. A single pile is $300 to $700 installed; pier and beam work, $2,000 to $12,000. Holliday's heavy Kamay clay can add depth, but one quote covers it.

How long does the work take in Holliday, and do we have to move out while it runs?

One to two days for a small job, two to three for a typical slab, four to five with interior piers. Nobody moves out. Power and water stay on while we work.

Why are doors sticking and brick cracking on houses in Holliday?

Kamay clay covers 35.2 percent of Holliday, more than any other town in the service area, at a linear extensibility of 7.5 and a plasticity index of 29. The 1984-median stock is often riding its first wet-dry swing rather than decades of old damage. Brick veneer cracks in a stair step first. See elevation survey.

Do I need a permit or an engineer's report in Holliday?

Permit rules are set by each town, so we confirm Holliday's rules with its building department before we start. Texas licenses no company in this trade, only a professional engineer (PE); a report is separate. Ask any company for proof of insurance and a written warranty.

Holliday carries more Kamay clay than Wichita Falls itself, under a much newer stock. We set piers here the same way we set them in town, readings first and quote second. Call (940) 202-0406 and we'll tell you what we see.

Get a written quote

Call (940) 202-0406 or send the form. The next step is a free on-site inspection and a written quote with every line item before any work starts.

Call (940) 202-0406

Get a free written quote

Call (940) 202-0406 Get a quote